by Andrew Beasl » Fri, 09 Feb 2001 04:31:27
Does any one know if these can be run together?
I am not too worried over loosing a reading or two but I do not want the
weather station to turn the lights on and off!
by Juss » Fri, 09 Feb 2001 17:23:08
Jussi
Quote:> I am looking at a weather station with remote sensors but it uses the same
RF
> settings as the X-10 remotes (433Mhz).
> Does any one know if these can be run together?
> I am not too worried over loosing a reading or two but I do not want the
> weather station to turn the lights on and off!
1. Controlling non X-10 Rf from X-10.
After trying to figure out what to with my ceiling fans for a few weeks now
(they were all installed with no switches), I found an RF remote control
unit for them. I had read quite a few threads here about there not being a
very good X10 solution for ceiling fans. I was pretty hopeful when I saw
that they had 16 different set bits for generating a unique RF signal. I
thought it might be X10 compatible. But I tried every house code with an
"All Units Off" and couldn't get it to do anything. I looked on the web for
information on these controllers (Hampton Bay) and can't find any
information even on their frequency.
I would like to be able to control them from my X10 software and was
wondering if there was anything out there that could learn an RF signal that
I could control from my computer of from X10 controllers.
Alicia
3. Measuring X-10 RF signal strength
4. ---Flex/Flash Developer---Hackensack, NJ---6+ Months Contract
5. WTT: X-10 for my X-10 or software
6. TRANSFER TAPES TO PC THROUGH SOUNDACARD,PLEASE HELP!
9. Direct X-10 RF with ProntoPro
10. X-10 RF Base WITHOUT built-in appliance module?
12. A message from X-10 re: Increasing RF range of receiver
13. x-10 Stores with X-10 Parts