I've created a batch file that I use to retrieve config files from my
routers via tftp.
Using Citrix Winframe 1.7 NT 3.51, the symtom is when I set this up it
works the first time ran, after I run it again the prompt goes to the
next line and blinks like its actually working. If I depress any keys
the command prompt types, and the process never starts or finishes.
Is there a cleaner way to setup batch files under NT, is there any
variables that I am missing. The actual batch file points to 20
routers, and like I said works the 1st time.
Any suggestions would be welcome, please email me directly at;
Also if anyone knows of any good books or whereabouts of docs that go
over advanced batch files for DOS or NT, (IF EXISTS, and GOTO's)
Rem "This command makes a backup of the existing config.scr files and
Rem "them in the appropriate directory."
rem 'Deletes backup files
rem 'Copies current files to the backup directory'
xcopy config.* e:\tftp\config\
rem 'deletes current config files.'
rem 'Start of tftp get program'
rem 'Corporate Office'
tftp 137.xxx.xxx.xxx get config.scr
copy config.scr config.scr
rem 'Sends copy of output to Admin for review'
----end batch --------
Walter C. Morris III
Network Systems Administrator
CNE (Wan Specialist)
Boole & Babbage
What is said here is based solely on the basis of personal
opinion and experience, and no way reflects any opinion or
judgement that my employer may have.