GVP/Micron conflict?

GVP/Micron conflict?

Post by Darius Taghav » Fri, 26 Jan 1996 04:00:00



Hi, does anyone know if the ASDG Micron 2 Meg memory
board work with a GVP GForce 50MHz 030 board in an A2000.
I'm considering to buy the Micron and the seller mentioned
that their might be trouble. If it won't autoconfig, is it
possible to disable autoconfig on the Micron (via a jumper)
and mount and addmem it?
Thanks much,
Darius
 
 
 

GVP/Micron conflict?

Post by P.K. Birkmey » Sun, 28 Jan 1996 04:00:00


: Hi, does anyone know if the ASDG Micron 2 Meg memory
: board work with a GVP GForce 50MHz 030 board in an A2000.
: I'm considering to buy the Micron and the seller mentioned
: that their might be trouble. If it won't autoconfig, is it
: possible to disable autoconfig on the Micron (via a jumper)
: and mount and addmem it?

A long time ago, I had an ASDG Micron 2 meg memory board.  That was
when I was floppy based (A2000).  When I got my first HD controller
card (A GVP product which had 2 or so meg of RAM on it) I tried to
put the two together.  

I could *never* get the ASDG board to config at all.  

I sold that board years ago.  I have since moved my A2000 to the
same GVP GForce board you have, but since the ASDG board is gone,
there is no way to test its compatibility now.

You may want to dump the same.  Heck, its only 2 meg, and those 256K
chips are getting very hard to find (although I got a couple dozen
laying around on my workbench).

PKB

: Thanks much,
: Darius
:
:

--
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
        PK Birkmeyer          __      |    "Where do you want to go today?"

        Hampton, VA        \XX/       |             an Amiga.

 
 
 

1. GVP Impact 3001 & Oktagon 2008AT conflict?

Hi there,

Anyone having problems using an GVP Impact 3001/030 together with a Oktagon
2008AT?

My problems started out while using the "Oktapussy" driver found on Aminet.
I get a recoverable
alert when I turn on the Amiga - and I get read/write errors on the
harddisk. When I dissable the
accelerator, everything works fine. When I unloaded the Oktapussy driver,
everything works fine -
but then I cannot use my harddisk, as it is not recognized!

Anyone with a similar problem out there? Any ideas?

Best regards
Henrik
Denmark

2. Training sites for vms training

3. GVP - PCMCIA slot conflict ????

4. rate-limiting by MAC address

5. A2620 and GVP HC+8 Memory Conflict

6. We still have a few weeks!

7. GVP Extended Mem conflict

8. Frontpage prevents me from erasing borders

9. GVP Hardcard and SupraTurbo conflicts

10. GVP 1230, PCMCIA conflict?

11. SCSI conflicting w/ serial on GVP 030 combo board

12. 2 GVP SCSIs conflict