by Ed Doyl » Mon, 26 Aug 1996 04:00:00
When I try to output a video on my Qmotion card, and the files
were rendered with motion blur, I get a distorted B/W type output,
almost like a bad deinterlace job.
Has anyone else using one of the MJPEG output cards had this problem?
If so did you find a cause or correction?
Thanx
Ed
--
1. Motion blur (was Re: Recommendation for animator for POV frame output)
Does anyone have any suggestions for doing motion blur in POV?
I compared POV and BMRT. BMRT is more powerful, but POV does a lot more
-- especially texture-wise -- right out of the box.
Also, it would be nice if POV implemented a shader language like BMRT.
Then you wouldn't have to keep adding to the code when a new type of
procedural texture has been created.
--
Jeff Garzik Fast and efficient news feeds
Spinne USENET News Service News tuning and consulting
http://www.spinne.com/usenet/ Cyclone, Diablo, and INN
2. DCT & fysical interpretation
3. Motion Blur.. Motion Blur.. Motion Blur
5. NEW VIDEO PLAYBACK BOARD!! Quadrant QMotion PCI
7. Could someone suggest a great video card 32 meg video card with video out
8. Job Opening at Improv Technologies
9. #9FX Motion 771 4MB VRAM 64-bit VLB Video Card
10. WTB Cosmo Compress motion JPEG video compression card
11. M-MOTION VIDEO CARD: YUV to RGB ?
12. M-Motion Video Card for the IBM PS\2
13. Video card with BNC outputs???