Autocad Release 13 Display Problems/Irix 5.3/Sgi Indy

Autocad Release 13 Display Problems/Irix 5.3/Sgi Indy

Post by Gord Gueri » Fri, 31 May 1996 04:00:00



We have purchased Autocad R13 for unix, version c2b/c3a, and installed it
on
a Silicon Graphics Indy workstation, running Irix 5.3.  The program bombs
when the following is attempted:
Open an existing drawing and select a line
Choose Modify Properties
Choose Modify Line
Choose Linetype Centre.

The error message is: ADI reply receive error.

A similar type of problem with R12 was solved by some new display drivers
from SGI.

Any solutions or suggestions?