by Lukasz Tylutk » Wed, 18 Jun 2003 20:58:52
I've got the small problem. I want to connect my HSG80 to host without
any switch or hub (I've no one, it's our test installation). I can't set
the Point-to-point protocol both on the machine (wwidmgr) and HSG80
controller. The result is, I've no connection to controller (doesn't
matter loop or fabric). Version of the ACS is 8.7S.
Do you know any way to make this connection?
Best Regards:
TYlut
--
Lukasz Tylutki, Gdynia, Poland.
by Wilko Bul » Thu, 19 Jun 2003 06:26:55
P2P is simply not supported at all..Quote:>Hi!
>I've got the small problem. I want to connect my HSG80 to host without
>any switch or hub (I've no one, it's our test installation). I can't set
>the Point-to-point protocol both on the machine (wwidmgr) and HSG80
>controller. The result is, I've no connection to controller (doesn't
>matter loop or fabric). Version of the ACS is 8.7S.
1. tunnel point to point vs physical point to point
If you have 2 systems on a point to point link you would address them
by a /30 block? When creating 'gre' tunnel you can use /32 for example
ip addr add 1.0.0.1 peer 1.0.0.2 dev mydev.
why can't /32 of arbitray addressing be used on a point to point
between 2 systems?
3. Point-to-Point-to-Point-to-Poi
6. Linux on IBM Power PC Computer ??
7. setting up ethernet connection as point-to-point
8. Nautilus dependency cyclic?
9. Point-2-Point Secured Connection
12. PPTP (POINT to POINT TUNNEL PROTOCOL)
13. sol2.4: What is the point of having a link point to the current directory?