Route-Trouble

Route-Trouble

Post by Neurauter Thom » Sat, 11 Feb 1995 22:27:42



Hi there!

My system-configuration:
   i486DX2-66
   16 MB RAM
   540 MB Quantum-SCSI
   1080 MB Quandum-SCSI
   Adaptec 1542cf-SCSI-controller
   WD-8003-Ethernet-board

My Linux release:
   1.1.88

My problem:
   Since updating to release 1.1.70 the 'network'-routing-table-entry
   gets lost after approximately 3 and a half minutes after coming up.
   Then, when I have re-entered this route-entry, there occurs no
   entry-loss anymore until reboot.

   Slowly I'm getting somewhat upset on having to Ctrl-Alt-BS the X-
   Server.....

Therefore I'd be very glad if anybody could let me know any clue on
solving this annoying little problem!

Thanx in advance,

:-) Thomas

 
 
 

1. Routing trouble with RH 5,maybe NE2000 trouble ??

I'm having trouble with a new installation of Redhat 5.Under
4.2,identical set up settings resulted in an instant working
system,but not under 5...Machine is AMD K5 with 64 megs,and a Virge
S3 video card,and SB16 PNP sound card.M/Board is an Asus TX-97 E

Setup is cable modem on a single fixed IP address.This is hung off a
generic NE2000 network card,that Redhat sees OK at boot up.

My machines fixed IP address is 195.44.34.159
The default gateway (cable modem) is on 195.44.34.1
Subnet Mask 255.255.255.0
DNS Server 195.44.33.2

I can't ping the default gateway (cable modem) on a numeric address
of 195.44.34.1  it just sits there 100% packet loss.

A command of netstat -rn gives the following:


Kernel IP routing table
Destination   Gateway    Genmask     Flags   MSS  Window irtt  Iface
195.44.34.0   0.0.0.0  255.255.255.0   U     1500  0       0    eth0
127.0.0.0     0.0.0.0  255.0.0.0       U     3584  0       0    lo
0.0.0.0    195.44.34.1 0.0.0.0         UG    1500  0       0    eth0

When doing a "route" command,the last line does not up until it has
been left alone for at least 2 minutes.That doesn't seem right.The
cursor sits after the immediate showing of the first 2 lines ,and
then 2 minutes later the last line pops up...

Doing a route -n I get all 3 lines appearing immediately.

I don't know what to try next,as under X windows,the Network
Configurator shows all settings to be appear correct.Can someone give
me any idea what's up ?

Thanks a lot!

--
             Best Regards,
                       Chris Wilson
                   http://195.44.34.159

2. terminfo HELP!!!!!

3. route-trouble

4. Is this secure?

5. ppp/route-trouble with SuSE 6.1 ??

6. Newbie Q : Info on scripts

7. Routing trouble!

8. HEALP -> Trying to find souce code

9. Routing Troubles

10. routing trouble

11. Please help newbie with Redhat 5 routing trouble

12. Basic Mail Routing Trouble

13. Routing troubles (RedHat 6.1/Wanpipe)