Swap Part.

Swap Part.

Post by AA » Thu, 22 Apr 1999 04:00:00



During a meeting I told me to replace one of the older LINUX servers.
My question during install I read that the swap part. is not needed when
the memory is higher then 32 meg. Myth or Fact?

Peace

AA

 
 
 

Swap Part.

Post by Matthew Pritzke » Fri, 23 Apr 1999 04:00:00



> During a meeting I told me to replace one of the older LINUX servers.
> My question during install I read that the swap part. is not needed when
> the memory is higher then 32 meg. Myth or Fact?

Swap is only unneeded if you are 100% sure you will not need more memory
than what is physically present.  About the only time this is true is
when you doing installation or some kind of single-user mode thing (eg,
maintenance).

32MB is really not very much on a PPC system; the rule I have always
heard is that swap should double the size of real memory.

--
--------------------
Matthew Pritzker                Graduate Research Assistant


 
 
 

1. RH 5.2 hangs when formatting swap part.

I am trying to install Red Hat Linux 5.2 and setup locks up my PC when
it is initializing the swap partition.  The keyboard is locked and the
HD light stays on.  I can only shut-off the PC or hit the reset
button.  I have:

300 MHz Pent. II
Shuttle HOT-641 mainboard w/440BX chip set
Matrox Mystique w/4 MB RAM
64 MB SDRAM
Sound Blaster 32 PNP
3 GB Western Digital EIDE HD on Primary chan.
Mitsumi IDE CD-ROM as master on Sec. chan.
HP/Colorado 5 GB IDE tape drive as slave on sec. chan.
SMC PCI ethernet card (DEC 21041 chip set)
USR Sportster 56k modem on Com 2
Logitech WingMan Warrior digital joystick on Com1
Logitech PS2 mouse

This hard drive used to dual-boot OS/2 Warp 4 and NT 4 wkstn, but I
removed all of those partitions.   I started setup and created the
partitions in Disk Druid, but when I have it initialize the swap
partition, the PC locks up.  I have tried this three times, but I get
the same lockup each time.

If anyone has any suggestions, I would appreciate them!

John
-----------------------------------------------------
John M. Clark

2. RedHat 6.0 and Japanese

3. Is it necessary to mount a swap part?

4. Installing Red Hat from a hard disk

5. size of swap part'n?

6. LINUX IP Forwarding -- HOW?!

7. Moving space from SWAP part' to /?

8. PROBLEM: solaris-i386-Linksys LNE100TX

9. swap part.

10. Which is better, swap part or file?

11. Swap Part

12. Linux & Windows using swap Part?

13. Linux Swap Space mini-HOWTO (part 1/1)