Running linuxppc 2000 on a c600 240. Runs well.
I'm a poor person and only have the original 56 Mb of memory and 1 Gb partition
(incl swap) so it's a little bloated and a little slow. I found Gnome to be slow,
so I'm using some smaller tools in the window management department.
(WindowMaker, I think)
Still haven't figure out how to apply the 603 patch to the kernel for Mac on
Linux, but I'm looking at recompiling the kernel to adjust for my smaller, older
setup. Any advice in this respect would be appreciated.
atb
b
> > Hi All,
> > Newbie as far as Linux goes.
> > Am trying to decide what is the best distro for my UMAX. It seems that YDog
> > says it should work. Anyone have Linux on a 603e/180 and how was
> > performance? I am looking only to setup an FTP, HTTP and some servlet or
> > JSP for hacking around.
> > I also have a VPower G3/240. Works well and I was hoping to use it with
> > Linux. This accelerator works by starting up in the Mac OS the initiates a
> > warm boot to the accelerator that sits in the cache slot. Its a long shot
> > but has anyone even tried to use one of these types of accelerators?
> > Thanks...Henry
> I am using a C500 200 mhz. LinuxPPC seems to run a little faster than
> MacOS 8.6... at least to me.
> --
> Rick
> * To email me remove theobvious from my address *
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 80,000 Newsgroups - 16 Different Servers! =-----
by