Hi All, I just installed V.011 SLS on an Ergo Brick with an LCD
monochrome monitor. It seems that after "x" number of lines I get a
split display of previous screen output. The only way to "reset" the
screen is to hit enter a few times until I clear a buffer (I think). At
any rate it works and I get a normal display again. When I was prompted
for video mode I chose 80x25. I'm not sure if this is the cause or not.
Does this problem sound familar to anyone out there ? I'm sure I have
something configured incorrectly but I'm not quite sure what.
* Origin: BCS IBM UG TBBS (617) 332-5584 (1:101/310)