Problem linking tcsh-6.00 on HP-UX 7.03

Problem linking tcsh-6.00 on HP-UX 7.03

Post by Steinar Ha » Wed, 17 Jul 1991 21:07:30



I am in the process of installing tcsh-6.00 on our HP-9000/400
systems, running HP-UX 7.03. I have successfully generated tcsh
using HP's own C compiler, and this one seems to work fine. Then
I tried to use gcc (version 1.40) instead, and I get the following
error message from ld:

ld: initialized data space not big enough for COMM declaration of _NumFuns

Does anybody know what is happening here?

Steinar Haug, system/networks administrator
SINTEF DELAB, University of Trondheim, NORWAY


 
 
 

1. SOLVED : LILO gives me L 00 00 00 00 00 00 00

To everyone who mailed me with there suggestions and for my answers here
it is.

I finally did some checking and found that my BIOS was pretty new and
that where
it specifies the hard drives there is a column called Mode. This goes
from 1 to
4 and is as follows.

Mode 1 = Normal - all cylinders, heads and sectors stay the same.
Mode 2 = Large - it doubles your heads and halves your cylinders.
Thereby getting
                 less cylinders. However for my drive it was still over
1024.
Mode 3 = LBA - it quadruples your heads and divides your cylinders by 4.
Thereby
               getting even less cylinders than Large mode. This left me
with
               cylinders =  621, heads = 64, sectors = 63 which use to
be
                         = 2484,       = 16,           63.
Mode 4 = Auto - Don't know what this is for, but it did not work for me.

This approach probably won't work for most people with older BIOS's.
Unfortuanately I could not get to a linux software solution after many
hours
of testing different setups and posts. Hope this helps someone.

:-)

-------------------------------------------------------------------------------
Mr Zahir Toufie, Systems Consultant, NHD IT (Info Tech) Cape Tech
-------------------------------------------------------------------------------
Fax. (W) 808 4102        
Tel. (W) 808 3580     (H) 633 2695     (C) 083 268 8301
    ** Use dial code 021 for National or +27 21 for International calls.
**
-------------------------------------------------------------------------------

Home Page http://www.sun.ac.za/local/admin/infoteg/ard_pers.html
-------------------------------------------------------------------------------

2. anyone using veritas database edition 3 for oracle??

3. Help LILO gives me L 00 00 00 00 00 00 00

4. Vtwm and pixmaps?

5. DHCP Server Leasing Addresses to MAC Addresses of 00-00-00-00-00-00

6. set maxphys = <8M> causes Ultra 5 IDE/ATA disks unsable

7. HELP: ifconfig reports hwaddr 00-00-00-00-00...

8. WANTED: INFO on kernel config info

9. make_recovery hp-ux v11.00 -10.20 ???

10. LILO / L 00 00 00 ... / Large Disk problems

11. tcsh-6.06 and HP-UX 10.xx

12. Ifconfig says "eth0 Link encap UNSPEC HWaddr 00-00-..."

13. RedHat 7.1 Ghostscript 7.03 Hp IJS driver