by >I have Adaptec 1542B SCSI host adapter and I have 3 SCSI devices on the
>SCSI cable namely: 1) Hard drive 2) CD-ROM 3) Wangtek Q150 tape drive
>When I boot up the system the Adaptec BIOS prints
>Check 0 LUN 0
>SCSI Hard disk
No. In all cases the LUN should be "0" since all of the devices thatQuote:>It does not recognize other SCSI devices (CD-ROM and Catridge Tape)
>How do I change the Adaptec BIOS to recognize other SCSI divces ?
>I think it should print
>Check 0 LUN 0
>SCSI Hard disk
>Check 0 LUN 1
>CD-ROM
>Check 0 LUN 2
>Cartridge Tape.
>Am I right ?
you have contain imbedded SCSI controllers. The Physical address should be
what each device is strapped as, on the device itself.
You should also run ASPI4DOS and ASPITAPE to get the most out of the
configuration. I have a Wangtek 150 MB tape drive, but I gave up on it - it
is a useless piece of steel and wires. I now use an Archive 2150S.
I hope this helps.
--
---
Michael Burke
Sea Change Corporation
6695 Millcreek Drive, Unit 8
Mississauga, Ontario, Canada L5N 5R8
Tel: 416-542-9484 Fax: 416-542-9479
UUCP: ...!uunet!uunet.ca!seachg!burke