hi,
anybody know how to make a bootable recovery Dat ( dds) tape for hp-ux 10.20
I know ver. 11.00 uses command make_recovery.
thx.
Hc
by hugo » Fri, 16 Feb 2001 22:49:05
anybody know how to make a bootable recovery Dat ( dds) tape for hp-ux 10.20
I know ver. 11.00 uses command make_recovery.
thx.
Hc
by Tom Hoffma » Sat, 17 Feb 2001 10:03:35
>anybody know how to make a bootable recovery Dat ( dds) tape for hp-ux 10.20
>I know ver. 11.00 uses command make_recovery.
1. SOLVED : LILO gives me L 00 00 00 00 00 00 00
To everyone who mailed me with there suggestions and for my answers here
it is.
I finally did some checking and found that my BIOS was pretty new and
that where
it specifies the hard drives there is a column called Mode. This goes
from 1 to
4 and is as follows.
Mode 1 = Normal - all cylinders, heads and sectors stay the same.
Mode 2 = Large - it doubles your heads and halves your cylinders.
Thereby getting
less cylinders. However for my drive it was still over
1024.
Mode 3 = LBA - it quadruples your heads and divides your cylinders by 4.
Thereby
getting even less cylinders than Large mode. This left me
with
cylinders = 621, heads = 64, sectors = 63 which use to
be
= 2484, = 16, 63.
Mode 4 = Auto - Don't know what this is for, but it did not work for me.
This approach probably won't work for most people with older BIOS's.
Unfortuanately I could not get to a linux software solution after many
hours
of testing different setups and posts. Hope this helps someone.
:-)
---------------------------------------------------------------------------
Mr Zahir Toufie, Systems Consultant, NHD IT (Info Tech) Cape Tech
---------------------------------------------------------------------------
Fax. (W) 808 4102
Tel. (W) 808 3580 (H) 633 2695 (C) 083 268 8301
** Use dial code 021 for National or +27 21 for International calls.
**
---------------------------------------------------------------------------
Home Page http://www.sun.ac.za/local/admin/infoteg/ard_pers.html
---------------------------------------------------------------------------
2. Identifying user of a TCP port
3. Help LILO gives me L 00 00 00 00 00 00 00
5. DHCP Server Leasing Addresses to MAC Addresses of 00-00-00-00-00-00
6. AIX 3.2.1: xdm leaves defunct processes
7. HELP: ifconfig reports hwaddr 00-00-00-00-00...
8. Anyone using SCO targeted binary on console?
9. Problem linking tcsh-6.00 on HP-UX 7.03
10. HP-UX 10.20 make_recovery fails
11. LILO / L 00 00 00 ... / Large Disk problems
12. BootMagic LILO hangs with 00 00 00...
13. Ethernet Address 00-00-00...