CTM and 3.2-STABLE

CTM and 3.2-STABLE

Post by Neil Hoggar » Wed, 30 Jun 1999 04:00:00

Hi Folks,

I've been running 3.2-RELEASE for a number of weeks, and I'm very
happy with it. I'm intending to start tracking 3.2-STABLE via CTM and
I had a query that I wondered whether anyone out there could help me

I've got the 3.2-RELEASE sources installed in /usr/src. The Handbook
suggests that RELEASE sources can be used to make a significant saving
on the initial download required to start off with CTM, but it isn't
obvious to me how I figure out what starter deltas I should download -
do the 3.2-RELEASE sources correspond to any particular src-3 delta

Neil Hoggarth                                 Departmental Computer Officer

http://www.physiol.ox.ac.uk/~njh/                  University of Oxford, UK


1. I have a SMP problem in FreeBSD 3.2 STABLE ctm 268

when I run setiathome x2  about one or two hours....

error message as follow and my system half.....

wd0: interrupt timeout (status 58 <rdy,seekdone,drq> error 1 <no_dam>)
 wd0: wdtimeout() DMA status 4
 wd0: interrupt timeout (status 58 <rdy,seekdone,drq> error 1 <no_dam>)
 wd0: wdtimeout() DMA status 4
 wd0: interrupt timeout (status 58 <rdy,seekdone,drq> error 1 <no_dam>)
 wd0: wdtimeout() DMA status 4
 wd0: Last time I say: interrupt timeout Probably a portable PC (status
 <rdy,seekdone,drq> error 1<no_dam>)
 wd0: wdtimeout() DMA status 4

My system is Intel celeron 300A 0c 495  on abit BP6

kernel config

# To make an SMP kernel, the next two are needed
options        SMP                     # Symmetric MultiProcessor Kernel

options        APIC_IO                 # Symmetric (APIC) I/O
# Optionally these may need tweaked, (defaults shown):
options        NCPU=2                  # number of CPUs
#options        NBUS=4                  # number of busses
#options        NAPIC=1                 # number of IO APICs
#options        NINTR=24                # number of INTs

if I close SMP , the system is work well....

please help me....

2. WD Driver Help

3. 3.2-STABLE to 3.4-STABLE device name change

4. upgrading

5. Using CTM to stay with 2.2-STABLE, where are the initial deltas?

6. Problem with Goldstar 580B

7. How to upgrade my FBSD 4.1.1-release to 4.1.1-stable using CTM ?

8. ppp started but won't last, looking for a how-to

9. Help!: Used CTM to updated to 4.0-STABLE and now can't login !

10. natd on FreeBSD 3.2-Stable really slow

11. problems compiling 3.2-stable

12. compilation pb: picoBSD 0.445 and last 3.2 Stable

13. FBSD 3.2 Stable and Netscape 4.61 Color Question