What is the correct procedure for switching to the pcvt console driver?
Jeffrey S. Sharp
In your kernel config file, disable the syscons-entry (starts withQuote:>What is the correct procedure for switching to the pcvt console driver?
Recompile your kernel. In the meantime read the docs and examples under
A better startup procedure for pcvt users is contained in PR7100, which
integrates pcvt configuration into the rc.conf/rc.i386 mechanism.
Hope this helps,
Hellmuth Michaelis Tel +49 40 559747-70
HCS Hanseatischer Computerservice GmbH Fax +49 40 559747-77
Oldesloer Strasse 97-99 Mail hm [at] hcs.de
22457 Hamburg WWW http://www.hcs.de
I have an installation of RH6.2 that I cannot telnet into. I try to connect
from my Windows box, and I don't even get a login prompt. Is this service
not enabled by default?
What is the telnet daemon called under RH62, and where do I configure it to
start at boot time?
I would like to set it to deny most IP addresses, as well.