Very Computer

I have a 3 button serial mouse which supports two or three button mode. The
modes are set by clear dtr/rts. It starts as 2-button mouse. In XFree86 I
use mousesystem type and clear dtr/rts to turn it into 3-button. However,
I have problem specifying it to selection -- if I specify it as mousesystem
3-button, I cannot use it until I use X. If I call it 2-button, I cannot use
it after X. So my question is --

Does selection have a way of sending clear dtr/rts to configure the mouse
in the first place?

Thanks!

--
   Eugene Ding                  Office: 4803 BH
   Computer Science Dept.       Tel: 310-206-2279
   UCLA                         Fax: 310-825-2273

Help!
I have a problem with Linux and would like some help.

I have Linux running on a 486 dx33 with 4 meg of ram
my drives are set up as follows.
/dev/hda1       -       Dos Partition (that boots) to DOS + Stacker 4
/dev/hdb1       -       Linux Main Partition mounted as Root & Whole File
                        system. 71MB
/dev/hdb2       -       Swap Drive 11 MB                        

I don't use Xwindows as i don't feel i have any use at the moment (also
lack of disk space) I am trying to get my fax/modem on com1 (cua0) to
answer and provide remote logins.
I have manged to set up uugetty to answer on callback but it doesn't send
the login: prompt after connect the system just sits there :-(
Can anyone help.

Mike Forster