Slackware 1.10, XFree86-2.0, Term 1.08 problem

Slackware 1.10, XFree86-2.0, Term 1.08 problem

Post by Nagi M. Aboulene » Fri, 12 Nov 1993 05:30:32



Hello Linuxers,

I just installed Linux using the Slackware 1.10 distribution, which
includes XFree86-2.0 and term 1.08. The kernel I use is version
0.99pl13. I am running on a generic 486 DX 33 machine, with a Cirrus
5426 based SVGA card.

I am experiencing problems using txconn to get X applications running
on a SPARCstation 10/30 (SunOS 4.1.3, X11R5) to display on my Linux
system. I have limited success running xterms through txconn
(``limited'' meaning sometimes it works and sometimes it doesn't). I
have no success at all running Emacs 19.19 or Lemacs 19.8. I get the
following error when I try to run Emacs or Lemacs:

        (sparc:~) emacs
        Xlib:  sequence lost (0x10000 > 0x3) in reply type 0x0!
        X Error of failed request:  0
          Major opcode of failed request:  0 ()
          Serial number of failed request:  0
          Current serial number in output stream:  3

Sometimes, the emacs window will show up on my screen, but die with a
similar error as soon as it gets any keyboard or mouse input. The
difference is usually in the "(0x10000 > 0xnnnn)" part, where the
"nnnn" varies.

Does anyone have a clue as to what might be the problem ?

Thanks,

Nagi

--
=============================================================================

 Computer Sciences Department                  Phone : Office (608) 262-6617
 University of Wisconsin-Madison                       Home   (608) 238-5215
 1210 W. Dayton St, Madison, WI 53706-1685     Fax   :        (608) 262-9777
=============================================================================

 
 
 

1. term 1.08 problem (modem hangs)

Hi, there:

    I just install successfully term 1.08 on my PC 386DX and on remote
sun workstation. Everything works very well except for one thing:

   It hangs there forever and I have to stop term locally to get every
opened window killed. (But the connection with remote is still there; I can
re-run the term without dialing again)

    Here is my modem: Practical Peripherals 14400.  I am using kermit on
my linux home.

    Here is what I saw:
modem tries to send signal to remote almost every 1 second, but receives
 nothing from the remote. This is observed at the front panel of modem,
 they are tx and rx lights. For normal operation, if I press a keystroke, the
 tx (send) blinks once, then rx blinks once(I guess that means: sends a
 signal to remtoe (tx) and gets an acknowledgement from the remote)

Can someone help me out ?
Thanks

Mike

2. Add 4G-1 file support to FAT32

3. Problem installing Slackware on 1.08 GB Drive

4. how to create /dev/video?

5. term 1.08 && v.42bis => !work

6. help me PLEASE : resolv.conf

7. Help: cannot get term 1.08 to work

8. Problems with setting up Colorado HP T4000s

9. Term 1.08 + what ftp?

10. Term 1.08 (blocking?)

11. Term 1.08 Hangs/Fails

12. Term 1.08 one way (with 16550A)

13. Term 1.08 sends nothing to remote host