by Before I waste any more time here, I want a question
answered: Will a Tandy CDR-1000 work with Linux?
If so, how?
If not, goodbye linux...
I have tried both the included Mitsumi driver,
and the lmsi/Phillips driver patch from sunsite.
The drive is on address 0x300 (I'm POSITIVE of this),
IRQ5, DMA1.
There is a driver that works somewhere, but I don't know
if I have it, or who has it.
Whoever was trying to sell his Tandy CDR-1000 in m.f.c.pc-clone
with a Linux driver must know something I dont, but I lost the
message, so I don't know who he is.
"The only good Mac is a dead Mac"
"The only good PC is a Linux PC"
"Fear SLIP at 2400 bps"
Disclaimer: The views expressed in this message are mine and not shared by
many, including ISC and especially Alfred State Computer Center.