Very Computer

I have a Compudyne 14" SVGA monitor which I purchased last summer.  The model
number on the back reads:  LR4G.

I'm trying to configure X for it (to run at 800x600), but it's not listed in the Monitors file,
and the tiny manual is useless as far as giving me enough info to run xf86config
correctly.

The monitor specs I'm looking for for this monitor are horizontal and vertical
scanning frequencies, at what (K)Hz, etc, basically what I need to specify the
monitor in XF86Config.

The specs I know about this monitor are its video Bandwidth is 65 MHz, it's
a .28 pitch, and runs in VGA, SVGA, and XGA modes.

Thanks in advance if anyone has this monitor running and can share their
knowledge.

Mark

=============================================

=============================================

I have the 15" version of what I imagine is the same monitor.  But you
need (much more importantly) to specify the video card you are using.
There is no reason I know of why you should be restricted to 800x600
with that monitor.  

Now, my model number (just looked on the back -- messed up my desk,
grumble, grumble) is KD-1500G, I think.  Maybe yours isreal different,
but I don't know.

Send me your card specs, and I'll see what sense I can make of it.

--

Department of Mathematics               http://www.lehigh.edu/~dlj0/dlj0.html
Lehigh University
14 E. Packer Avenue                     (610) 758-3759
Bethlehem, PA 18015-3174                (610) 828-3708