by Hi. I'm having a little trouble with term.
Here is my problem. After much confusion and hacking, I've gotten term to
work. However it is unbelievably slow. I have a USR Sportster 28800 but
my 'cps' when tmon is running is very jumpy from about 1700 to 100
when I'm running an x application on the remote computer and the information
is being sent to my local computer. Anyway, I ran linecheck on both
machines, and the local computer had a linecheck log as follows (I just
copied the first few lines and the end of the output):
Handshaking
Handshaking successful
0 sending char
invalid packet: Handshaking sucessful
invalid packet: 0 sending char
0 received valid
1 sending char
invalid packet: 0 received valid
invalid packet: 1 sending char
1 received valid
2 sending char
invalid packet: 1 received valid
invalid packet: 2 sending char
2 received valid
3 sending char
invalid packet: 2 received valid
invalid packet: 3 sending char
3 received valid
4 sending char
invalid packet: 3 received valid
(the middle I cut out because it was all the same)
(the end of the files follows):
251 received valid
252 sending char
invalid packet: 251 received valid
invalid packet: 252 sending char
252 received valid
253 sending char
invalid packet: 252 received valid
invalid packet: 253 sending char
253 received valid
254 sending char
invalid packet: 253 received valid
invalid packet: 254 sending char
254 received valid
255 sending char
invalid packet: 254 received valid
invalid packet: 255 sending char
255 received valid
invalid packet: quit
invalid packet: invalid packet: done
On the machines, the commands that I typed were (on the remote)
'linecheck'
and on the local machine I typed
'linecheck < /dev/cua1 > /dev/cua1'
I'm not sure what is going wrong. I'm new to this whole linux thing
and the problem here could be something very easy. I've read all the
HOWTO's and such but I've haven't been able to figure it out. Some
info that I know is that my term is ver 2.3.5 and the remote's term
is 1.0.8. However I downloaded the most recent linecheck
from ftp.funet.fi for my remote system's unix version which is UNIX(r)
System V Release 4.0. on a Sun4. Also I am running slackware 3.0. I
would be greatly indebted to you for any help that you could provide.
Thank you in advance.