I am looking for the settings or an example to try to setup 320x200
display. There are times when this mode would be helpful.
Also a 1152x900 mode line would help.
Gateway Crystalscan 17 (not gateway computer) and
a Cirrus Logic 5426 1 meg card
by Robert Pers » Sat, 02 Dec 1995 04:00:00
Also a 1152x900 mode line would help.
Gateway Crystalscan 17 (not gateway computer) and
a Cirrus Logic 5426 1 meg card
1. Help: generic svga uses builtin 320x200 mode
Hi,
I am setting up X on my Toshiba Tecra 500CS. I am using the generic
svga device driver so I expect to have a 800x600 screen. However,
it is not the case. When I run X -probeonly, , it said the svga is
using the builtin mode 320x200. How can I change it to 800x600?
Any pointer will be appreciated. Thank you.
waldo
2. AIX 3.2.5 boot diskette set ?
3. <HELP> SVGA Xserver only uses "builtin" 320x200 mode
4. Valid Baud rates slattach for DU 3.2c
5. Can XF86 do better than 320x200 for "generic SVGA" card ?
8. XFree86 Always in 320x200 Mode
9. Getting XFree86 3.1 to run in 320x200 mode
10. DOOM, X, Linux, 320x200 video mode ??
12. 320x200 only x mode??? XF86 config problems