Help for modeline with ATI WINTURBO mach64

Help for modeline with ATI WINTURBO mach64

Post by Stavros Tsirakidi » Tue, 08 Apr 1997 04:00:00


I have an "ATI (mach64) WINTURBO with 2MB VRAM"
and a "miro D1786T" monitor. Now I am using the
mode 1280x1024 with 256 colours:

Modeline  "1280x1024" 135.00 1280 1312 1416 1664 1024 1027 1030 1064

But I would like to use the mode 1152x864 with
65K colours and in the user's guide from my card
there is a mode table, where is written:

Screen          Refresh         Horizontal              Pixel
Resolution      Rate (Hz)       Frequency (kHz)         Clock (MHz)
1152x864        80              76.3                    110

Does someone know, which modeline I should use ?

The specifications from my monitor are:

Horizontal Frequency :  30-86 kHz
Vertical Frequency :    50-152Hz
Video Amplifier:                50Hz - 135MHz
Blanking time:          Horizontal < 2.9 sec (typ.)
                        Vertical        < 0.35 sec (typ.)



1. Help getting ATI WinTurbo Mach64 PCI to work with X!

I managed starting all modes (640,800,1024 with 8/16/32bpp-except 1024)
with an ATI Mach64 / 68860 "Spectra" Ramdac, but using the old 3.1.1
I tweaked a little the timings but it worked. One annoying thing was
the server would crash if the computed clock was out of monitor's specs.
Anyways, I couldn't get the 3.1.2b running. I ftp-ed now the 3.1.2 to
what it can do.




| Network Administrator
| for node

2. counting matching occurences

3. HELP: Mach64 Server crashes with ATI WinTurbo

4. Newbie: adding new module as autoload

5. Pls HELP: Getting ATI Mach64 WinTurbo to work.

6. Configuring dip for dynamic IPs

7. S: Modeline for Sony GDM17E11 with Mach64 WinTurbo

8. iptable question

9. ATI Winturbo Mach64 VLB - Setup solution

10. ATI Mach64 WinTurbo/ProTurbo difference?

11. Need: xconfig for ATI WinTurbo Mach64 (PCI)

12. Does ATI WinTurbo PCI Mach64 work with XFree86?

13. ATI WINTURBO Mach64 and X