by I have a Compaq Proliant 1000 server. It has a SCSI adaptor built
on the motherboard. I thought it was a NCR53c7xx chip, but the
NCR53c{7,8}xx kernel driver doesn't detect it. Do I need to specify
parameters to lilo? If so, can someone with a similar setup please
send me their lilo.conf.
Currently I have an Adaptec 1542 card which conflicts with the onboard
at boot, even when the onboard is disabled through the BIOS. It makes
me press a key to continue. This is a problem because it needs to have
an operator at console for boots. :( We are using Red Hat 4.2 with
the 2.0.30 kernel.
Thanks in advance!
Brian Murphy