by Richard H. Almquis » Sat, 22 Aug 1998 04:00:00
The Ethernet-HOWTO doesn't list this card but it uses the DEC 21140
chip so I think it may work with linux. Can anyone confirm this?
For a two node network, can I use a crossover cable instead of a hub?
Is there any advantage to a hub other than supporting more nodes?
Thanks
Richard Almquist
1. D-Link 10/100 (DFE-530TX) Mbps NIC Support?
I've found that it is supported (vr0), but I'm actually have
a hardware /bios detection problem. Still need help with Samba however.
--
; Student in Computer Science (B.S) * Washington University, St. Louis ;
; "Trust the CompInd to shorten 'Year2000'->Y2K. It was this kind ;
; of thinking that caused the problem in the 1st place." -Anon. ;
3. Which driver for nic D-Link 10/100 model DFE-530TX REV-A3
5. D-Link DFE-530TX 10/100 PCI network card not supported by Redhat 6.0
6. Info???
7. Is the D-Link DFE 530TX 10\100 PCI NIC compatible with Linux?
9. D-Link DFE-530TX 10/100 PCT card???!!!
10. D-Link DFE-530tx Rev A-1 and DFE-530tx Rev D2
11. linux drivers for a D-Link DFE-503 TX 10/100 mbits NIC
12. D-Link DFE-530TX NIC configuration
13. D-Link DFE-530TX NIC trouble