Plug & Pray ???

Plug & Pray ???

Post by Walter L. William » Wed, 02 Dec 1998 04:00:00



Greetings

Does anyone know what happened to the WEB site that had the Linux PNP
stuff. I am wanting to get my SB card working. Last I heard the Linux
PNP stuff was working.

Many thanks

Walt Williams

 
 
 

Plug & Pray ???

Post by Brian Mille » Tue, 08 Dec 1998 04:00:00



> Greetings

> Does anyone know what happened to the WEB site that had the Linux PNP
> stuff. I am wanting to get my SB card working. Last I heard the Linux
> PNP stuff was working.

> Many thanks

> Walt Williams

Walt,

Take a look at my web page on getting my ESS 1868 sound card working.
A SoundBlaster card should be pretty much the same to get going.

   http://www.netspace.net.au/~bmiller/linux/ess1868.html

Brian
--
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Brian Miller                                 Telstra
CDN Product Group                            30/242 Exhibition Street
ITG Communication Network Platforms          Melbourne, VIC 3000

Tel: +61-3-9632-3883                         FAX: +61-3-9632-3884
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=

 
 
 

1. plug & pray: NCR 53c810 & Asante 10/100

I am having troubles with a couple PCI devices, and am not sure if it
is a kernel, hardware, or configuration problem.  The problem stems
from the fact that both my NCR SCSI card and my AsanteFast 10/100 think
that they have been assigned IRQ 9, as shown during boot...

kernel: scsi-ncr53c7,8xx : NCR53c810 at memory 0xffbffc00, io 0xfc00, irq 9
kernel: eth0: 21140 (DEC 21140 Tulip) at 0xfc80, 00:00:94:75:4e:0f, IRQ 9

"ifconfig eth0" prints

eth0      Link encap:10Mbps Ethernet  HWaddr 00:00:94:75:4E:0F
          inet addr:144.92.12.192  Bcast:144.92.12.255  Mask:255.255.255.128
          BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0
          TX packets:0 errors:0 dropped:0 overruns:0
          Interrupt:9 Base address:0xfc80

"ifconfig eth0 up" prints

SIOCSIFFLAGS: Try again

My motherboard is an Intel Plato clone.  IRQ's 5, 9, 10, and 11 are
marked as being available in the BIOS setup.  I am not sure if my
PCI slots are bus mastering or not, but the ethernet card is.

Any help is greatly appreciated.
Mike

--
Mike Gerdts

CAE Unix Systems Staff
University of Wisconsin, Madison

2. SunVideo on Ultra 8 with Solaris 8

3. plug&pray modem problem

4. Diamond Viper 32MB TNT2 Video Card

5. Plug&Pray - Free Hardware Support Service

6. NT Breakin

7. Plug&Pray Mouse?

8. Installation problem

9. Plug&Pray - Free Hardware Support

10. Plug & Pray ???

11. PCI Plug&Pray - help!

12. Plug&Pray - Free Hardware Support Service