Board index Linux Hardware

Intel EtherExpress Pro/10

Intel EtherExpress Pro/10

Post by Mike Lo » Wed, 18 Sep 1996 04:00:00



Hello,

I'm having trouble setting up my ethernet card...

I have an Intel EtherExpress Pro/10 card connected to a Pentium running
Slackware version 3.1 (kernel is version 2.0.0).  I am using the default
kernel (IDE support only) that gets installed when you install disk set
A.  Ethernet card support gets loaded at boot-up time by uncommenting a
line in the /etc/rc.d/rc.modules file.  The result is that on boot-up,
the Ethernet card gets detected (address and IRQ found OK), but when I
try to telnet, ftp, etc., nothing happens -- the machine just seems to
hang (but it can ctrl-c it).

I've run the netconfig program to set up my machine IP address, name
server IP address, etc. also.

I am certain that my ethernet card is hooked up properly, because I can
connect to the network when I run off my DOS/Windows 3.1 partition.

Any help here is greatly appreciated!

Mike

 
 
 
Top

1. Install Intel EtherExpress Pro 10/10+ ISA card on Redhat 6.1 ---Please help

Hi,

I installed RedHat 6.1 on my PC(dual boot 98/Linux). Everything is fine
exception the RedHat can't recognize my ethernet card( Intel
EtherExpress ISA Pro 10/10+). The card works fine in 98.

During the installation, RedHat couldn't detect my card at all. So I
tried to load it manually. I tried two ways:
1. I put ether=5,0x210,0,0,eth0 ( the conf in my 98) in lilo.conf, then
reboot the machine. During the boot, lilo couldn't start eth0.
2. I run lsmod, I found nothing there. I do have
/lib/modules/2.2.12-20/net/eexpro.o file, so I said insmod eexpro. The
linux hangs forever. I have to power off the machine.

What did I do wrong? Please help!

Regards,
Michael

* Sent from RemarQ http://www.remarq.com The Internet's Discussion Network *
The fastest and easiest way to search and participate in Usenet - Free!

2. CFDISK - where ?

3. Intel EtherExpress Pro/10+ with RedHat5.1 problem

4. SCO apps under FreeBSD

5. Intel EtherExpress pro 10

6. Odd mouse problems

7. Intel EtherExpress Pro/10

8. FreeBSD problem...

9. Intel EtherExpress Pro 10/100

10. 3c509 & Intel EtherExpress Pro 10

11. Intel Etherexpress Pro/10+ ISA problem

12. Intel EtherExpress Pro/10+ v11.0 and 2.1.127

13. RedHat 6.0 & Intel EtherExpress Pro+ 10/100+Management PCI Ethernet Card


All times are UTC
Board index