CD-ROM Compaq CR-503 on Adaptec AIC-6360

CD-ROM Compaq CR-503 on Adaptec AIC-6360

Post by beth » Thu, 04 Apr 1996 04:00:00



Is Compaq CD-ROM CR-503 (SCSI), connected to Adaptec AIC-6360 (SCSI host
on SoundBlaster 16) supported by Linux?

If it is so, where can I get the driver, or how can I modify
existing drivers to make Linux know my CD-ROM?

tia

 
 
 

1. Adaptec AIC-6360 for SCSI NEC CD-ROM via Soundblaster CT1770 card

I used the same hardware and Linux distribution on my first Linux box
and had good success, so read on!

When you are prompted for boot parameters in the initial setup, enter
the following substituting the correct values for IOPORT, IRQ and
SCSI-ID:
aha152x=IOPORT,IRQ,SCSI-ID,1

Possible IOPORT values: 0x140, 0x340 (default)
Possible IRQ values: 9, 10, 11 (default), 12
Possible SCSI-ID: 7 (default)
Disconect SCSI Devices: 1

My boot parameters were:
aha152x=0x140,11,7,1

During the LILO configuration setup, you will prompted to enter any
additional parameters.  Re-enter the parameters you used during the
initial setup.  These will then get entered in /etc/lilo.conf.

Good luck.  If you have any problems, e-mail me.


2. Question on select() with thread.

3. Correction To Solved Getting ADaptec AIC-6320 Its really AIC-6360

4. Prevent X users from switching to virtual consoles

5. Chinon 535 SCSI CDROM & Adaptec AIC-6360 BIOS

6. laptop installation

7. redhat 4.0 and Adaptec AIC-6360

8. Sound configuration with Redhat 5.2 and the 2.0.36 Kernel

9. Chinon 535 SCSI & Adaptec AIC-6360 & Linux

10. Adaptec AIC-6360 SCSI adapter

11. Adaptec AIC-6360

12. HELP: Adaptec AIC-6360 V 1.01L and Fujitsu M2694ES-512 disk

13. Adaptec SCSI AIC-6360 And Linux Slackware