by Hi, I've recently just gotten all the modules to load for my
MicroSolutions Backpack CD-RW, but have had quite a bit of trouble
finding documentation on the CD-writer, rather than the plain CD-ROM. I
am able to load the parport, paride, bpck6, and pg modules (the pg one
took some extra parameters, which were rather a pain to figure out). I
can also load the pcd module, and mount the device on /cdrom. But, when
I attempt to do a cdrecord -scanbus this is the output I get: "cdrecord:
Device or resource busy. Cannot open '/dev/pg0'. Cannot open SCSI
driver." I can't think of anything that would be tying up the drive, so
am rather stumped. Right now I am loading the pg module by: "modprobe
pg drive0=0x290,0,19". I know there are extra parameters one can add at
the end as well, but don't know much about them, and don't know if they
would rectify the problem anyways.
Thanks in advance,
Janina