Very Computer

I have a problem whereby I've installed Redhat Linux on a 1GB SCSI drive, no
problems there, but during installation it did not see the SCSI adapter.
Therefore I told it to use:

        aha152x=0x340,11,7,1

And everything installed fine. I created a boot floppy during the
installation as the SCSI adapter is not bootable. Only problem is that the
disk will not boot. It gets as far as outputing beginning of the LILO
message and then outputs 01 01 01 etc continuously.

My real question is, can I boot Linux from Dos using something like LOADLIN,
but be able to pass the SCSI adapter parameter detailed above. I don't seem
to be able to succeed beyond this point.

Shame really, coz I was looking forward to getting my teeth into Linux.

Hope you can help, thanks,

Dave

Quote:> My real question is, can I boot Linux from Dos using something like LOADLIN,
> but be able to pass the SCSI adapter parameter detailed above. I don't seem
> to be able to succeed beyond this point.

Quote:> Shame really, coz I was looking forward to getting my teeth into Linux.

=---------------------------------------------------------------------=
-        Thomas Zajic aka ZlatkO ThE GoDFatheR, Vienna/Austria        -

=---------------------------------------------------------------------=