SI 3112
using wd ata66 drive with abit SATA/PATA converter
drive shows up in M$ but not linux
sda/1/b/2 are not present
any ideas?
drive shows up in M$ but not linux
sda/1/b/2 are not present
any ideas?
Are you using your distro's kernel or one you rolled? Need's scsi andQuote:> SI 3112
> using wd ata66 drive with abit SATA/PATA converter
> drive shows up in M$ but not linux
> sda/1/b/2 are not present
> any ideas?
Thorn
--
"I was gratified to be able to answer promptly, and I did. I said I
didn't know."
-- Mark Twain
>>SI 3112
>>using wd ata66 drive with abit SATA/PATA converter
>>drive shows up in M$ but not linux
>>sda/1/b/2 are not present
>>any ideas?
> Are you using your distro's kernel or one you rolled? Need's scsi and
> libata support. Assuming ata66 can be a real SATA device...
> Thorn
I did both kernel types.
what ended up fixing it was putting the hdd jumper in the right place(DOH!)
I am using a SATA-PATA converter, it comes with some sata equiped ABIT mobo.
I have an ATA66 hdd connected and forgot to set it for single drive mode.
thanks again
Hi,
i m using 64 bit AMD processor on mother bord K8S-MX..i tryed linux-9
AS-3 fedora-3 fedora-4...none support sata HDD..its 200 G.B. SATA
HDD...
Help me with installing Red HAt Linux 9.0 with SATA HDD support....
This is giving me sleepless nights...
Thanks,
Manish
2. New or Revised TAs on websco, 960710
3. Need advice on PCI SATA controller & Redhat
7. SATA HD Help
8. linksys with bad irq setting
9. SATA Drives on Intel MB w/ Fedora core 1 - HELP
10. HELP REGARDING SATA Hard Disk DRIVER
11. Need help getting connected, bootp help needed
12. ARCNET Drivers Needed for Linux...help help help!
13. <help>Linux newbies need help with CD and soundcard<help>