Very Computer

I have installed an ATL L500 tape library with an DLT 7000 drive.  I can
use the DLT drive with no problem, but I can't seem to get the library
robot to work under RedHat 6.2.  I am not sure which device to use or
which driver to use for the loader/library.  The host detects the SCSI
tape at /dev/st0, but there is nothing for the loader.  Can anyone
suggest where to begin on this.  Below is the output from dmesg for the
SCSI adapter.  Thanks for any help.

scsi1 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.28/3.2.4
       <Adaptec AIC-7896/7 Ultra2 SCSI host adapter>
scsi : 2 hosts.
(scsi0:0:0:0) Synchronous at 10.0 Mbyte/sec, offset 15.
  Vendor: ATL       Model: L500     6320000  Rev: 0021
  Type:   Medium Changer                     ANSI SCSI revision: 02
(scsi0:0:1:0) Synchronous at 20.0 Mbyte/sec, offset 15.
  Vendor: QUANTUM   Model: DLT7000           Rev: 2560
  Type:   Sequential-Access                  ANSI SCSI revision: 02
Detected scsi tape st0 at scsi0, channel 0, id 1, lun 0
scsi : detected 1 SCSI tape total.

--
When all else fails, read the documentation.

Andrew G. Bacchi
Sr. System Administrator
AIRS
Hanover, NH

I have a similar problem, I have an HP optical jukebox, but I can't  get
any software for the changer to work, it would just get errors, since the
   commands it sends are different.  I finally  decided to write my own.
ATL might have a SCSI command reference on their website like HP does.  Also,
MTX might work if you don't have any software.  You will probably have to
 make a device for the changer itself, or use one of the SG* devices,  
 probably it would be /dev/sga.  There is a driver for scsi  librarys with
 the robot on a different id,  try looking for "Linux SCSI changer
 driver".