Very Computer

by **Thomas Jentzsc** » Wed, 28 Apr 1999 04:00:00

Hi
I got an ISDN S.0 Card (IDE-Bus) from CREATIX and would like to use it
with Linux. There's no manual coming with it, the only 2 jumpers on the
card determine the adress of some i/o registers (D800, F000, etc) and
that's it.
Does anybody know whether the card can be used with Linux and what
necessary configurations steps are to be done in order ot get the damn
thing to work ?
Thanks a lot.
Thomas

by **M.C. van den Bovenkam** » Thu, 29 Apr 1999 04:00:00

> Does anybody know whether the card can be used with Linux and what
> necessary configurations steps are to be done in order ot get the damn
> thing to work ?

The older non-PnP Creatix is a clone of the Teles S0/16 (warning: *not*
the S0/16.3!). Which is supported by Linux, so it should work. I have
one of them, but I'm not using it with Linux (my gateway machine has a
Teles S0/16.3 in it).

Regards,

--
Marco van den Bovenkamp.

CIO EMEA Network Design Engineer,

Lucent Technologies Nederland.
Room: HVS BZK 32
Tel.: (+31-35-687)2724

Very Computer

Creatix ISDN S.0 card

Creatix ISDN S.0 card

Creatix ISDN S.0 card