I want to print in linux, I've used printtool, printtool shows that nothing
is being detecting on my parallel port, which is where my printer is, how do
i get linux to recognize my parallel port.
thanks in advanced
by Russel » Thu, 06 Apr 2000 04:00:00
thanks in advanced
by Peter Cathcar » Thu, 06 Apr 2000 04:00:00
alias parport_lowlevel parport_pc
To the file /etc/conf.modules
This should allow printtool to recognise your printer.
Pete
by Peter Bloomfiel » Thu, 06 Apr 2000 04:00:00
1. parallel printer port setup problems
Hello
I cannot use my printer on my new box (I could with the same printer on
my hp pavilion 5255), I just build a box on a qdi titanium tx
motherboard. the // port is recognized by the kernel, but if I type ls
In the bios, I can set the port's adress to 0x378, irq 7 (default) or
0x3bc irq 7. There are many parallel port mode (spp ecp epp 1.7 or 1.9
or ecp + epp) I think I've tried all of the settings, the kernel always
tells me that he sees the port but will always send "/dev/lp1" out of
paper to the messages. I already tried tunelp but didn't success, thank
you for your time.
3. Hooking Real world input to Parallel Printer port
5. First release of BiTronics parallel printer port device driver
7. RH4.2 parallel printer port doesn't work.
8. IP MASQ
9. Parallel Printer Port Speed...?
10. parallel port printer and parallel port superdisk
11. Multiple parallel ports/IRQ sharing/non-use of IRQ by parallel ports?
12. emulating a parallel port printer? Or, reading lpt0???
13. Unable to detect printer on parallel port