by <LE.. » Mon, 11 Sep 1995 04:00:00
Hi,
I have the Graphics Pro Turbo Mach 64 card with 4m Vram on a VESA
motherboard. When running xf86config the cards supported are the
Xpression, GUP Turbo ? , and WinTurbo. Is my card supported ?
openwin does start up and I do get the Linux opening color but it
reboots the machine ? If anyone has the card I'm talking about could
you giv me a hand :)
thankx
lenny c
1. ATI Graphics Pro Turbo mach64
Keywords:
I have installed the above card and configured it with xf86config and it
works with all the resolutions which can be switched around with cntrl alt
+numeric.
However there is a slight problem that it displays about 90% of the
screen, missing about 2cm on the left and 1cm on the top. This must be a driver
problem as when I use windows95 with the ATI drivers the whole screen is used.
I can always correct with the monitor amplifiers but would have to
re-adjust when using windows95.
Has anyone else seen and managed to correct this problem?
--
Cheers Bev.
*************************************************
* Tel Switzerland (022) 7672482 *
* Fax Switzerland (022) 7673100 *
*************************************************
--
Cheers Bev.
*************************************************
* Tel Switzerland (022) 7672482 *
2. Does TRU-64 support devices with block sizes > 512 bytes/block ?
3. ATI Graphics Pro Turbo - Mach64
4. kdev_t changes cause NVdriver compile failure?
5. Sony 17se & ATI Graphics Pro Turbo (Mach64)
7. MetroX in 64K/16.7M colors/1024x768 and ATI Graphics Pro Turbo (Mach64) Problems
8. Master Boot Record - Resetting
9. Solaris x86 2.4 and ATI Graphics Pro Turbo (mach64) video
10. Problem: ATI Mach64 Graphics Turbo Pro 2Mb (PCI)
11. Cannot get X going with ATI-Mach64 Graphics Pro Turbo
12. XFree86 and ATI Mach64 Graphics Pro Turbo
13. XF86 with ATI Mach64 Graphics Pro Turbo