by Hi,
I am also looking for a similar solution. I haven't been able to get my
Oxygen card to work in any graphics mode except 640x480 from the SVGA
driver. I am not against re-installing 3.3.6 if this is known to get some
results. Anyone have any ideas? Oddly enough the mouse pointer is often
visible when it is trying to activate a graphics mode.
Cheers,
Nicholas.
-------------------------------------
> Has anybody managed to get 3DLabs Oxygen GVX1 work with xfree 4.0.1?
> It's a bit confusing if the card is supported at all.
> HP hardware compatibility list says it is (XFree3.3.6+FBdev) but
> there's nothing about Permedia 3 chip on xfree.org
> The log file is strange too...
> XFree86 Version 4.0.1a / X Window System
> Release Date: 2 August 2000
> ...
> 0xf8000000/26, 0xf4000000/26
> ...
> (II) GLINT: driver for 3Dlabs chipsets: gamma, ti_pm2, ti_pm, pm3, pm2v,
> pm2, pm, 300sx, 500tx, mx
> (II) Primary Device is: PCI 04:00:1
> (WW) GLINT: No matching Device section for instance (BusID PCI:4:0:0)
> found
> (--) Assigning device section with no busID to primary device
> (--) Chipset pm3 found
> ...
> (II) GLINT(0): Unknown Glint Permedia3 board detected
> ...
> AUDIT: Tue Oct 24 12:36:34 2000: 1771 X: client 7 rejected from local
> host
> thanks for any hints.
> Ivan
> --
> Ivan Zimine
> Dpt. of Radiology
> Geneva University Hospitals