trouble installing emacs-20.2 with Caldera linux-base 1.1

trouble installing emacs-20.2 with Caldera linux-base 1.1

Post by Paul Kimo » Mon, 23 Feb 1998 04:00:00





> Upgrading libc isn't trivial. In /lib you'll find libc.so.5.4.22 and also
> a symbolic link libc.so.5 that points to it. Running programs use
> libc.so.5. [...] When you upgrade
> to a new minor version you need to install libc.so.5.x.xx and libc.a

Actually, for libc5 you don't need libc.a unless you want to link programs
statically.  (However, with libc6 == glibc, you _do_ need both for the
system to run.)

Quote:> and change the symbolic link to point to the new libc.so.5.x.xx.

> But libc.so.5 must point to a valid libc at all times, as most programs
> use it. So you must copy the new files to /lib first, then change the
> symbolic link in a single step

Don't mess with the symlinks by hand.  The command "/sbin/ldconfig" will
automagically update the symlink for you.

--
|||    "It was not granted you to complete the task, and           |||
|||     yet you may not give it up."      --Rabbi Tarfon           |||

 
 
 

1. Anyone had success installing emacs-20.3 on AIX 4.3.2 ??

I installed emacs-20.3 on AIX 4.3.2 without any problems. (i.e. no errors in
compilation, make or make install). However, when I attempt to execute it I
get the following:

                Segmentation fault(coredump)

I would greatly appreciate any ideas as to what might be causing the
problem. Thanks for your help.

Daniel Rosenfeld

2. Incorrect Accounting

3. Trouble installing CDE on Caldera Open Linux base 2.0.25

4. Need file /etc/mount for HP UX 10.20

5. Caldera base 1.1- support for PCI NE2000 clone card

6. Help about dtbuilder

7. Can you use umsdos in Caldera Base 1.1?

8. Need multiple image directories

9. ppp connection with Caldera Base 1.1

10. Installation with Caldera base 1.1

11. PCI NE2000 clone card. Caldera 1.1 Base

12. looking for xedit under Caldera OpenLinux Base 1.1

13. Can you use umsdos in Caldera Base 1.1?