Board index Linux

SIOCADDRT: Network is not reachable

SIOCADDRT: Network is not reachable

Post by Filip Hoste » Fri, 29 May 1998 04:00:00



Hello,

While configuring my toshiba portable (ethernet via pcmcia, 3com
3c589D).
 i still get the error with the route commands :
SIOCADDRT: Network is not reachable
I have installed the ethernet card using the howto's.
Only control-panel from redhat can do the ethernet card work and then
everything is ok. (so nothing is wrong with the kernel and -modules)

Probably i'm not configuring it properly. I used the Net-2 howto to
update my /etc/rc.d directory.

Anybody knows why i get that message ? Please mail me.

Filip
--
    Filip Hosten, Dept. : VE118, Alcatel Design Centre Chennai India
    Internat. phone : +91 44 234 9961 ext 7135,

 
 
 
Top

1. SIOCADDRT Network not reachable

Hi.
WHen my system boots, it states that it has found my ethernet card,
then I see a "SIOCADDRT" immediately after it says that it's found my
ethernet card at 0x300.
Afterwards, when I manually run the following three commands, it fails
on the third command with a "SIOCADDRT Network not reachable" error
message.  The first 2 commands run fine.

        root# ifconfig eth0 192.168.1.10 netmask 255.255.255.0 up
        root# route add -net 192.168.1.0 netmask 255.255.255.0 eth0
        root# route add default gw 192.168.1.1 eth0

If anyone can shed some light on this, I would appreciate it.  It's
keeping me up at night!

Thanks,
Phillip

Sent via Deja.com http://www.deja.com/
Share what you know. Learn what you don't.

2. deleteing unwanted zero's after the dec point

3. network not reachable problem

4. Help! Trident TGUI9680 With XFree86

5. help newbie "network not reachable"

6. Network Config Lost After Reboot

7. Ping : Network not reachable

8. No TCP/IP

9. Network not reachable ????

10. WD8003 & 1.1.88: Network not reachable

11. Network not reachable problem

12. network not reachable

13. LinuxPPC 1999: Network not reachable


All times are UTC
Board index