libbfd.sp.2.5.21.11

libbfd.sp.2.5.21.11

Post by E. Gorm » Mon, 20 May 1996 04:00:00



Ok... I just (re)installed Linux(Slackware 3.0.0 A, AP, and D), and
tried to do some compiling.  When I do, it always exits with the
error:

as: can't load library libbfd.so.2.5.2l.11

Now... I've got gcc(2.7.0), libc(whatever comes with slackware),
binutils, the source, and everything else needed to compile.  What
is this library?

E. Gorman


 
 
 

libbfd.sp.2.5.21.11

Post by Pat Thoyt » Tue, 21 May 1996 04:00:00



>Ok... I just (re)installed Linux(Slackware 3.0.0 A, AP, and D), and
>tried to do some compiling.  When I do, it always exits with the
>error:

>as: can't load library libbfd.so.2.5.2l.11

>Now... I've got gcc(2.7.0), libc(whatever comes with slackware),
>binutils, the source, and everything else needed to compile.  What
>is this library?

If you try `grep libbfd /var/adm/packages/*' you can find out which
package it was actually in. However, having recently done this - I'm
fairly sure it's comes with binutils and in this Slacware release i think
it's on D1. So if you installed the D series it should be in /lib

If it isn't - you could search for the binutils.tgz and manually install
that with installpkg. However, it looks more like you did a partial
upgrade over a previous slackware. If this is so you are probably better
off to backup you own data and configuration files and reinstall from
scratch. The jump from a.out to ELF is too much of a pain to cope with.

--


 
 
 

1. syncronous serialcards (V.11/RS-422sync,v.35,x.21)

Hi,

Anybody know a basic, cheap syncronous serialcard (V.11/RS-422sync,V.35,X.21
or other general standard) with speed 64k-128k (or above) for PC/ISA bus.
If so is there linux driver for it. If not I would be willing to write
one if just find a suitable card. I know of EICON card, but it's
intelligent and quite expensive. ARNET also has one intelligent card
little cheaper. But what I'm looking for is stupid cheap card only with
necessary address and irq logic and syncronous IO-chip (whit FIFO).
Those chips are not very expensive so the card shouldnt be either.


Pekka Sarnila

--
-------------------------------------------------------------------
Pekka Sarnila,  University of Jyvaskyla Finland

-------------------------------------------------------------------

2. Lost Interrupt?

3. Compliance with 21 CRF Part 11

4. SMP on FreeBSD 3.0

5. libbfd.so.2.5.2l.11 - where can I find it??

6. SVR4 for 386.

7. PC-9800 additional for 2.5.61-ac1 (11/21) parport

8. Inarguable advice: Buy yourself a modern PC and donate your obsolete Mac to a needy school!

9. ANNOUNCE: web2ldap release 0.11.21

10. LDAP problems moving from 2.0.11-13 to 2.0.21-1

11. libbfd.so.2.5.21.11 MISSED!! HELPME TO FIND IT PLEASE! ;-)

12. How to map <tab> to <sp><sp><sp>?

13. LILO 21 barfs w/msg about "pre-21 LILO signature"