HELP -- MACH64 driver

HELP -- MACH64 driver

Post by Shu Ch » Wed, 16 Aug 1995 04:00:00

Hi, I am a new-comer to Linux and trying to install XFree86. My hardware are:

   ATI mach64 with 2M-DRAM
   MAG DX17F 17" monitor

I use X -probeonly to see what Doc Clock I shoud use, it give me several very
low figure, such as 25.3  ..., which seems does not correct.

How should I figure out the correct parameters.

Thanks for your help.

Shu Chen
Graduate School of Library and Information Science
University of Texas at Austin


1. help Mach64 driver

Hi  I got hold of a copy of the open server SCO was
 giving away. I installed it with out too much difficulty but my
video is meesed up and I can only log in as  superuser In ANSI mode.
I am wodering do I have to reinstall or can I download the patch for
Mach 64 in SU mode( I have the patch on a diskette dos format). To
download I would have to configure an internet dialer.

Any suggestions would be appreciated


2. Is it possible to install LinuxPPC onto an RS\6000 type 7248 133?

3. Mach64 driver from AHS ver.5.1.0j ???????????? HELP!

4. Getting ssh, ftp, & telnet lag from my server

5. Please Help -> X Driver & Mach64 - ATI G Xpression.

6. difference between Sun StarOffice and MS Word's HCI design.

7. Help with Mach64 accel driver...

8. SCSI tape kernel configuration woes

9. Stuck at 8 bpp with Mach64 driver! HELP!

10. Help needed on ATI mach64 driver

11. Mach64 card w/Mach64 or SVGA Xserver

12. ATI Mach64 PCIQ: ATI Mach64 PCI, Xwindow problems ?

13. HELP Mach64 ISA and Metro-X server HELP!!!!!!