Board index Linux

Redhat 6.2 installation errors

Redhat 6.2 installation errors

Post by gtx1.. » Mon, 21 Aug 2000 11:21:49



Hi, I have downloaded distribution of RH6.2 Linux and I'm attempting to
install it to an intel box with no current operating system. I get
through the install script fine (using text install mode) but then it
ends with error 'signal 9' and shuts down the kernel. Any suggestions?


Sent via Deja.com http://www.deja.com/
Before you buy.

 
 
 
Top

1. RedHat 6.2 Installation question

We have a Compaq ProLiant 3000r server with a SmartArray 431
controller installed. When installing Red Hat 6.2 from the CD, we are
able to get through the entire installation process without any
hangups. It's seeing the RAID as a single drive, we partition it using
Disk Druid, and we're writing to the MBR without any error messages.
At the end of the process, it says to reboot and remove the
installation media. We do that, it powers back up, and then...nothing.
A black screen with a blinking cursor. Frankly, we can't figure out
why the process would be failing.

Anyone have any ideas?

2. unknown mailer error 1

3. Redhat 6.2 Installation problem

4. Utilities similar to `last'

5. RedHat 6.2 re-installation fails

6. mincom - function key

7. Redhat 7.0 & 6.2 installation stops

8. Processing mail

9. modem installation redhat 6.2

10. zyxel omni.net installation on linux (RedHat 6.2)

11. Can't Get RedHat 6.2 to Reboot After Installation

12. Newbie - RedHat 6.2 installation Impressive, but where is the user interface???

13. RPM installation on Redhat 6.2


All times are UTC
Board index