Very Computer

1. routing tabels loosing default route using PPP

Hi,

I have written to the net about this before, but then it was bonched together
with a lot of other stuff so there might be someone out there that didn't
read it because of this:

My problem:
        A route added by route add default xxx.xxx.xxx.xxx gets lost
        by the system wo. any complaints or explanations.

Call sequence:
        1. pppattach xxxxx
        2. ifconfig -a gives me the negotiated IP-address
        3. route add default xxx.xxx.xxx.xxx
        4. netstat -rn shows the route as expected
        5. Misc commands, ftp, telnet, Mosaic.... Doesn't matter.
           Works fine for some time. The stops.
        6. netstat -rn shows that the deafult entyr in the table has dissappeared ?
        7. Another route add default xxx.xxx.xxx.xxx works fine and gets everything
going again.
        8. Usually doesn't happen again.

I can't see any correlation to any action I do on the net or on the machine.

The System:
        Corollary 8x4 Serial MUX
        Multitech ZDX Modem 28.8k (Did the same with myolder Dynaling 14.4k)
        CPU Cyrix 5x86 (The same symptoms with the previous 486DX2-50
        Openserver 5.0 with 5.0.0d patch and net100 patch.

Any hint  appreciated.

Hi from Finland

--

Oy NewTech Ab                            phone: +358 0 8024910
Trasktorpet 3                              fax: +358 0 8024916
02360 ESBO                                 NMT: 9400-426312
FINLAND

2. SMTP relay with SENDMAIL

3. Default route OS5 PPP

4. Linux <- Maximum processes ?

5. How do I add default route for PPP interface as non-root user?

6. Programming kernel modules

7. specifying source address on default route in PPP (help!)

8. IRCd for Redhat 6.2

9. Multiple default routes over PPP after 2.6 upgrade

10. changing default route after ppp connection.

11. Changing the Default Route for PPP??

12. User PPP not adding default route

13. PPP Default Route Problem