HELP: Fax package for RH5.0 needed

HELP: Fax package for RH5.0 needed

Post by Greg Robert » Wed, 29 Jul 1998 04:00:00



Hi all. I'm currently working on a job that requires a fax package to be
installed on a RH5.0 machine. I would like to know what packages are available
for Linux, and any hints, advice people can pass on in helping me with setting
up these packages. I have tried to setup Hylafax, but I'm running into some
config problems, so I thought I'd find out if there were other packages I could
use. The machine is a Pentium II 300MHz, 64MB, 4GB. The fax package would have
to allow users to mail their faxes to the fax server to sending. The
server won't allow incoming faxes, only outgoing.

Could people please reply to the E-mail address below.

Thanks,

Greg

--------------
Greg Roberts

Computer Systems Officer
Dept. of Electrical & Electronic Engineering
The University of Western Australia
NEDLANDS WA 6907 Australia

Ph    : +61-08-9380-7366
Fax   : +61-08-9380-1065

 
 
 

1. Boca fax modem problem with fax. help!

Folks!
I've put my hands on Boca MV28KI fax modem. It is 28,800 bps, and I
can't force it to work in the fax mode. When I send something
over it stops the transmission after several dots on the paper
appear, so it look s like it sends only the first portion of
data. Then it interrupts. Before that, though, it writes some
kind of warning about XON/XOFF junk. I tried it under Dos and it
worked there. So, I looked the initialization string and found
"&K3" which supposes to turn CTS on. I have put the one in
efax but still... It doesn't work. The settings are that the beast should
bargain for the connection speed. Did anybody experience anything
similar?

--
++++++++++++ http://sunsite.oit.unc.edu/sergei/Me/Serge.html ++++++++++

+Department of Physics & Astronomy, UNC-CH, Chapel Hill, NC 27599, USA+
++++++++++++++++++ !! 8 bit (Cyrillic) mail accepted !!++++++++++++++++

2. restarting accept in sig handler ??

3. I need help to install packages, setup ftp can you help??

4. X on ATIMach64GT

5. again posting HELP urgent help needed :please tell me from where to get gunzip package

6. XFree86 for Matrox MGA G400 display card

7. need help on choosing a fax/modem

8. System won't boot after install with 2nd SCSI disk

9. Hayes Accura 28.8 V.FC + Fax help needed

10. 600Series FAX Modem configuration help needed

11. UNIX FAX PROGRAMMING (NEED HELP)

12. NFS help: RH5.2 i386 - RH5.2 Sparc

13. Help with upgrade from RH5.1 | RH5.2 to RH6.1