Memory Check on Ultra10

Memory Check on Ultra10

Post by Mathias Waac » Thu, 31 May 2001 21:16:25


I'm looking for a way to check the memory on an Ultra10 sparc box. The
OpenBoot manual tells about a check /memory command. But my box tells me
"No selftest method for /memory". Are there any other ways to do this?



1. ultra10,sol2.8,IDE check this out question

This is how i repartiioned my IDE drive on my ultra10 station
for sun solaris 2.8 installation. Drives are internal ST39120A.
1. "ok cdrom -s".
2.format ->partition->priont->modify the all except 2.
3.q  (saved it)
4.q  (save and exit)
5.init 0
6.ok>boot cdrom c0t0d0s0 "/", c0t0d0s01 "swap", c0t1d0s0 "/opt". as i set it up
this way in format. the installation.
9.Installation finished without any errors.
10.Right now it is working. All i have to do is to install applications.

df -k reveals / is 7% full and /opt is 1% full. I am not too picky
and that is how i set it up.

Am i on the right track?. is this OK?.

Sent by    from yahoo part from com
This is a spam protected message. Please answer with reference header.
Posted via

2. Start of Discussion Linux vers NT

3. How to check the amount of free memory in share memory

4. 'UNDUMP' for Solaris?

5. Ultra10 , Ultra5 memory bus differneces.

6. inn problems redhat 4.2

7. Memory problem on Ultra10?

8. 1600x1280 with Matrox Millennium II AGP

9. Ultra10 memory

10. Newbie: Memory management with Solaris 7 on Sun Ultra10

11. How to find out the memory size used by a process or check its memory leaking?

12. dbx memory run-time-checking does not work

13. Memory Checking