by Did anybody have a Gigabit Lx tranceiver and Sun Server or workstation on a
Vlan(here is on 2 vlan) on a HP Procurve 2524 and have 0% of packet loss ???
Here is my configuration :
Solaris 8 on a ultra-30
2 NIC
local-mac-address = true
Vlan 1 for a subnet 192.x.x.x = hme1 for Sunray
Vlan 2 for a other subnet 168.x.x.x = hme0
Trunk with the LX tranceiver port to the router (cisco)
RSTP enable with :
Switch Configuration - Spanning Tree Operation
Protocol Version : RSTP
STP Enabled [No] : Yes
Force Version [RSTP-operation] : RSTP-operation
Switch Priority [8] : 8 Hello Time [2] : 2
Max Age [20] : 20 Forward Delay [15] : 15
Port Type Cost Priority Edge Point-to-Point MCheck
---- --------- + --------- -------- ---- -------------- ------
1 10/100TX | 200000 8 Yes Force-True Yes
2 10/100TX | 200000 8 Yes Force-True Yes
3 10/100TX | 200000 8 Yes Force-True Yes
4 10/100TX | 200000 8 Yes Force-True Yes
5 10/100TX | 200000 8 Yes Force-True Yes where
is the Sun Ultra-30 (hme0)
Trk1 | 2000000 4 No Force-True No
I have some lost packet with the server on the vlan 2. But i don't loss any
packet with a Mac or Windows Stations....any idea, hints ???
The switch did not recognize the mac adress on the port(5) with the Ultra-30
on it ( hme0 ) i think that is the problem....any idea, hints for this too
???
Port Type Cost Priority State Designated Bridge
---- --------- --------- -------- ---------- -----------------
1 10/100TX 200000 128 Forwarding 000883-24bc00
2 10/100TX 200000 128 Forwarding 000883-24bc00
3 10/100TX 200000 128 Forwarding 000883-24bc00
4 10/100TX 200000 128 Forwarding 000883-24bc00
5 10/100TX 200000 128 Disabled
i think than i can't put manually a mac-adress for a port on this switch....
Thank's in advance
Chamby