Can not boot after install solaris x86(2.5 and 2.6) using AHA-1542CP.

Can not boot after install solaris x86(2.5 and 2.6) using AHA-1542CP.

Post by Dann » Fri, 19 Sep 1997 04:00:00



Hello,

    I can not boot after install solaris x86 2.5 and 2.6 using AHA1542CP.
The error message is "Requested Cylinder is beyond range of BIOS geometry".
The manual p10-22 say disabe synchronous Negotiation,
support for More Than Two Dos Drives,
Dynamically Scan SCSI Bus for BIOS Devices..etc.
I am done,but can not working.
Please help me.

Thank you very much.

Danny.

 
 
 

1. Cannot boot after install solaris x86 2.6 using AHA1542CP.

Hello,

    I can not boot after install solaris x86 2.6 using AHA1542CP.
The error message is "Requested Cylinder is beyond range of BIOS geometry".
The manual p10-22 say disabe synchronous Negotiation,
support for More Than Two Dos Drives,
Dynamically Scan SCSI Bus for BIOS Devices..etc.
I am done,but can not working.
Please help me.

Thank you very much.

Danny.

2. cdrecord problem (power calibration area is full)

3. Can software compiled for Solaris 2.5 be used in Solaris 2.6?

4. trident tgui9440ati server release?

5. AHA-1542CP, drive >1GB, OS/2 Boot Mgr, LILO dies after "LI".

6. About installing FreeBSD!

7. AHA-1542CP hangs system during boot

8. uudecode fails with "No end line"

9. Informix problems afters Y2K Solaris 2.5 patch

10. ELSA Gloria-L under Solaris x86 2.5/2.6?

11. Best price for Solaris x86 2.5 -> 2.6 upgrade

12. how to install solaris 2.5 x86 to 2.5 gig WD HD

13. problem installing x86 2.5 with update 3 and Adaptec AHA-1542C