> Hello,
> I was hoping somone could help me...... it's little off topic as it involves
> hardware.....
> I have a Sun Ultra 30 with Creator Series 2 (FFB2) graphics card.
> I would like to use it with a Diamond XEN1510P 15.1" TFT Monitor (13w3
> adaptor) but the display will not work because the horizontal sync rate from
> the graphics card is too high 76Khz.
> Monitor Scanning Frequencies: (V) 56~75Hz ,(H) 31.5 ~60KHz
> Is it possible to use a different graphics card ? or do I have to use a CRT
> (eg Sun/Sony) display with this system ?
> Any help would greatly appreciated.
> Cheers Nik
Try to strap the connector to the lowest rate as the URL below shows,
you could do this with fbconfig also and then you have more options.
bash-2.05# /usr/sbin/fbconfig -prconf
--- Hardware Configuration for /dev/fb ---
Type: single-buffered FFB2+
Board: rev 2 (Vertical)
FBC: version 0x2241906d
DAC: Brooktree 9070, version 1 (Pac2)
3DRAM: Mitsubishi 130a, version 1
EDID Data: Not Available
Monitor Sense ID: 6 (Sun monitor)
Monitor possible resolutions: 1024x768x77, 1024x800x84, 1152x900x66,
1152x900x76, 1280x1024x67, 1280x1024x76, 960x680x112s, 960x680x108s
Current resolution setting: 1152x900x76
http://www.gruftie.net/ibm/13w3/13w3_pinout.html
/michael
by