Very Computer

I have carefully set the adapter to the settings on page 45 of the Device Configuration
Guide without any luck.  The original install disk and the DU7 disks give the same results.

The system runs LINUX, Win95 and NT fine.  The termination appears to be ok (though I
haven't taken then out and tested them independently).

Any suggestions greatly appreciated.  Please mail response because I will be out of town for
a few days.

Thanks.....
Neil

Did you set IRQ somewhere between 9-15?
(Mine is 11).

Did you set DMA channel to 6. I think Sol 2.4 for x86 supports only 6.

--

    Personal Media Corp.                  
  Shinagawa, Tokyo, Japan 141

Quote:>I am pretty much in the same boat -- I have followed instructions on page 45

Any ideas.
--
                           : "The giant Gorf was hit in  one eye  by a stone,
Andy Pitts                 : and that eye  turned  inward  so  that it looked

                           :   --_The Forgotten Beast of Eld_, McKillip--