by Mike Walter » Tue, 13 Mar 2001 02:49:01
by Andrew Gabri » Tue, 13 Mar 2001 04:03:09
It will be the same name as the primary, except d1 instead of d0.Quote:>Hi, this is a super newbie question
>I just installed a second atapi drive on Solaris 8. It is 20GB.
>In linux, there is /dev/hdb or /dev/sdb. How do I know what my second
>hd is and how do I make fs?
>It is on same cable as the primary HD, and set to slave.
If the /dev/dsk nodes don't exist, run devfsadm -v
(or do a reconfiguration boot: touch /reconfigure; reboot)
--
Consultant Software Engineer
1. New Install on New HD with an Old HD Copy question
I am relatively new to using Linux and had a question about copy files
from one HD to another.
Had a Redhat 7.1 install that was working fine until I got hit with
the Linux.Slapper.Worm. So I decided to just buy a new harddrive and
install Redhat 8.0 on it. Now, since I was doing some webhosting on
this system, I need to pull over the files from my old HD's
/home/httpd/html dir and put it on the new HD. Problem is, during
bootup, it always installs the old HD even though it's been put second
on the IDE chain and is SLAVE to the new HD. Anyone have a suggestion
to make the old HD available from the new HD Redhat install so I can
just copy those files over?
If I posted this in the wrong place, my apologies.
Thanks in advance.
3. Can Netscape Enterprise Server bind two ip address
4. Trouble trying install Solaris 10 in a new HD
5. Help! RedHat Linux 5.1 has problem recognise my HD partitions
6. ATAPI+ Buslogic, Install of New OS
7. Get ipop3d messages out of maillog
8. Problems with an IDE HD and new SCSI HD
9. Setting up 2 new SCSI HD in a system with an IDE HD
10. How to replace dying HD with new HD?
11. New/fast HD with old/slow HD
12. New/fast IDE HD with older HD