digiboard Xem on Solaris 2.4 x86

digiboard Xem on Solaris 2.4 x86

Post by Sean Colli » Wed, 30 Aug 1995 04:00:00



--
Sean Collins

University of Florida Department of Chemistry

 
 
 

1. need: dial-in modem config for 2.4 x86 & Digiboard Xem

Hello,

I'm facing big trouble while configuring the dial-in lines on a Pentium running
Sol2.4 x86 and a Digiboard Xem.

I guess I need to do a sacadm once, then making a pmadm for each port, as
described in a faq found on http://access1.sun.com. Is it correct ?

Another problem : I configured the stuff to use the line with modem control
activated (/dev/dty/a001m instead of /dev/dty/a001s), but when I call the
modem, it answers for a few seconds then hangs up, before modem synchronization
complete. Is it possible that the Sol2.4 sends the login prompt before the
modem completes synchronization, which maks the modem hang up ?

Any advice on the setup of a dial-in modem (even without a multi-serial
board) will be greatly appreciated.

Thanks in advance.

--
 >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
/Jean-Francois "Jef" Stenuit | Interpac Belgium NV/SA       |    // Amiga    \
\Internet administrator      | 350/358 Avenue Louise Box 11 | \\//  fanatic  /
/Phone (32)(2) 646-6000      | B-1050 Brussels              |  \/            \
\Fax   (32)(2) 640-3638      | Belgium                      | & SparcStation /

<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<

2. Partition Help!

3. Solaris 2.4 x86, aspppd, Digiboard CX

4. PageUp and PageDown does not autorepeat

5. Solaris 2.4 X86 Digiboard drivers needed!!!

6. PD Zmodem for Solaris

7. Digiboard PC/Xem

8. Network is unreachable for loopback

9. Mgetty and a Digiboard Acceleport XE with XEM 16 port box

10. PPP on Solaris 2.4 for Sparc, Matrox PCI Millenium Card under Solaris 2.5 x86

11. Digiboard Xem 16 port box

12. Solaris 2.4 x86: How to sync Solaris and CMOS time?

13. moving from SPARC solaris 2.3 to x86 solaris 2.4