Help: My cd-rom does not recognize audio cd

Help: My cd-rom does not recognize audio cd

Post by Shad » Wed, 26 Jun 1996 04:00:00



I am running solaris 2.4 x86 on Pentium 90 w/32 mb or RAM.  I just
downloaded and installed Workman cd player.  My cd-rom works fine with
regular cd's but when I put in Music cd, it gives this error message.


                 Error for command 'read(10)'  Error level:Fatal
             Requested Block 0, Error Block:0
             Sense Key: Blank Check
             Vendor 'Toshiba':
             ASC=0x64 (illegal mode for this track), ASCQ=0x0, FRU=0x0

I have Toshiba quad speed connected to Sound Blaster 16 scsi2 card.  
Someone suggested that I disable volume manager.  So I tried running
workman with volume manager off.  Workman would rung but there is no
sound and gives the same error message in command tool window.

Thanks in advance.

 
 
 

1. Help: My cd-rom does not recognize audio cd.

I am running solaris 2.4 x86 on Pentium 90 w/32 mb or RAM.  I just
downloaded and installed Workman cd player.  My cd-rom works fine with
regular cd's but when I put in Music cd, it gives this error message.


                 Error for command 'read(10)'  Error level:Fatal
             Requested Block 0, Error Block:0
             Sense Key: Blank Check
             Vendor 'Toshiba':
             ASC=0x64 (illegal mode for this track), ASCQ=0x0, FRU=0x0

I have Toshiba quad speed connected to Sound Blaster 16 scsi2 card.

Thanks in advance.

2. POSIX or SYS5 signal (sa_sigaction)

3. CD-ROM not playing audio CDs

4. Linux Screen Shot...

5. CD-ROM device recognized, but not the CD format

6. Hack attempt? /_vti_bin/_vti_aut/fp30reg.dll

7. Help playing audio CD's on my CD-ROM drive

8. Voice over IP -- VOIP

9. Help - CD-ROM won't play audio CDs.

10. CD-ROM not detected by linux after CD-ROM install

11. Help. T130B SCSI + NEC CD-ROM Not Recognized.

12. Help kernal not recognising CD-ROM

13. HELP: HPFS partition, CD-ROM not recognized!